I am using the connect on demand feature for my wireguard VPN, which works fine. The automatic disconnection, if connected to certain WiFi SSID works well too.
I would like to access a single address in the VPN network to retrieve some data, which takes less than a second. After that, the connection can be closed again. Under Global options/VPN options I checked Disconnect when the VPN is inactive with the parameters 10 seconds and 1024 bytes. So I expect to drop down the connection after 10 seconds. But even after minutes the connection is alive. I checked the throughput in the monitor (unter STATUS), which was verifiable nothing.
So any idea about this behaviour?
Automatic disconnect does not work
Re: Automatic disconnect does not work
I will take a look tomorrow...
Re: Automatic disconnect does not work
You're right.
I forgot to implement this feature in the WireGuard backend.
The problem will be fixed in the next release.
I think that it will be available the next week.
Thank you for the bug report.
I forgot to implement this feature in the WireGuard backend.
The problem will be fixed in the next release.
I think that it will be available the next week.
Thank you for the bug report.
Re: Automatic disconnect does not work
The problem has been fixed in new release 1.00.30
Please, update the app.
Please, update the app.